Doepfer Musikelektonik logo

Analogue  Modular  System  A-100

Width

HP

Depth

mm

Current

mA

Lighning Flash

Owners Manual

EMIS_email Glen Cottage,  Moorslade Lane,  Falfield,  nr Bristol, GL12 8DJ EMIS_Logo

( Please contact first before visiting)

100x60_box

Sales info

Micro Keyboard (Transmit / Receive)

The A-173-1/2 is a module combo that is used to generate a manually controlled 1V/Octave CV signal and up to 15 manually controlled gate/trigger signals. Typical applications are the transposition of a sequence by means of the CV output (without the need of an external keyboard and CV interface) and the manual generation of gate signals for start, stop, envelope generator triggering and other trigger tasks.

The A-173-1 is the transmitter module and is made of a 1 ½ octaves micro keyboard and a three-position octave switch.

The A-173-2 is the receiver module and generates several gate/trigger signals and a 1V/Oct. CV signal. The upper section of the module is used for the gates which are controlled by the corresponding buttons of the A-173-1. Each output can be programmed as gate (pressing/releasing the corresponding key turns the gate on/off) or toggle (pressing the corresponding key changes the state). The state of each output is displayed by an LED.
The lower section of the module is used the generate a 1V/Oct. CV signal and gate signal in the usual way.

By means of the learn feature of the A-173-2 (i.e. defining the key for 0V CV) a few buttons can be separated from the CV generation section so that these buttons only control gate/trigger outputs without affecting the CV. That way e.g. start/stop or other triggers become independent from the CV section. For example it's possible to separate the lower five buttons (G to B) from the CV generation and use these buttons only for the generation of gate signals. For this the lower C has to be defined as lowest key for the CV generation.

The modules communicate via standard midi note on/off messages and are connected internally by means of a 2-wire cable. That way the modules can be mounted at different positions within the case.


Maximum current requirement is only when all LEDS are on, which is unlikely to occur.



No Manual

12

45

10HP

100

10HP

A-173.1/2

Doepfer A-173.2